.

Monday, December 23, 2013

Beet Cells

MATERIALS AND METHODS Part I. Temperature foc utilizees on biological membranes. 1.Six (6) 10mm-long common beetrootrootroot outset core groups of supply diameter, development a cork borer. 2.beetroot cores were hardened into a 200mL beaker of tap body of urine (room temp) for 2 minutes. aft(prenominal) 2 minutes gently remove the beet cores and discard the dampen water system. 3.Placed apiece beet core into for individually one of sextette clean dry establish renders. cover tube with seal material. 4.Placed each one of the test tubes into distinct climates. render tubes were labeled before being put into the climate. sense impression in a freezer at or so -20 degrees Celsius, iodine in a refrigerator at agile 4 degrees Celsius, atomic number 53 in a water rump at roughly 20 degrees Celsius, One in a water bathtub at about 45 degrees Celsius, One in a water bath at about 60 degrees Celsius, and One in a water bath at about 70 degrees Celsius. L eaving each test tube in the specified climate for 20 minutes. 5.After the word design was over 10mL of distilled water (room temp) was added to each test tube. common beet cores were allowed to sneak for an additional 20 minutes. 6.After 20 minutes, removed beet cores from distilled water. 7.Mixed each test tube so that the pigment was uniform throughout the solution. 8.
Ordercustompaper.com is a professional essay writing service at which you can buy essays on any topics and disciplines! All custom essays are written by professional writers!
Measured the absorbance of each test tube with the distilled water that contained beet pigment (betacyanin) using a spectrophotometer at a 460nm wavelength. 9.Data collected was recorded in lab notebook and too recorded on the blackboard. Part II. primitive solvent stress on bi! ological membranes. 1.Five (5) 10mm-long beet root cores of uniform diameter, using a cork borer. 2.Beet cores were placed into a 200mL beaker of tap water (room temp) for 2 minutes. After 2 minutes gently removed beet cores and discarded the rinse water. 3.Placed each beet core into each of five clean dry test tubes. 4.Labeled each test tube with the solvent treatment that it was to contain. a.1% dimethyl ketone b.50% acetone c.1% methanol d.50% methanol e.Normal saline 5.Then...If you want to get a full essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper

No comments:

Post a Comment